San Diego RS-232 sniffer installation
Electronic Design for Embedded Systems User Guide
RS232 monitoring hardware
Engineering consultants San Diego, CA
   
 
Data and Voice Communications San Diego consultants Com port analyzer
Stratus Engineering Quick Start Guide
C and C++ software engineer Firmware designer - engineering services in San Diego
EZ-Tap Pro Quick-Start Guide

EZ-Tap Pro Device Driver Installation

Please visit our downloads page to download the latest copy of this file and the EZ-Tap/EZ-Tap Pro device drivers and installation guide for your operating system. Note that EZTap and EZ-Tap Pro use the same device driver. The typical user will unzip the driver files into a directory on his/her hard drive and use the Windows hardware installation wizard to complete the installation. If this does not work for you, refer to the instructions in the appropriate driver installation guide for help.

Once the EZ-Tap/EZ-Tap Pro driver has been correctly installed, EZ-Tap Pro will be shown as a USB COM port under Windows Device Manager.

EZ-Tap Pro Firmware update
After the EZ-Tap Pro device drivers have been successfully installed, please update the EZ-Tap Pro embedded firmware, which is also available on the downloads page. To do this, simply download the latest firmware installation program to a folder of your choice and then unzip and run the firmware installation executable file.

EZ-View RS232 Monitor Application
Stratus Engineering’s EZ-View RS232 Monitor program Version 1.3.0.1 or higher is currently the only application program available for use with EZ-Tap Pro. EZ-View now works with EZ-Tap Pro as well as EZ-Tap and offers the same user interface for both devices. The only difference between the two devices from the EZ-View user standpoint is that EZ-View provides exact microsecond time-tagging for all data and handshaking events when used with EZ-Tap Pro. You can download the latest version of EZ-View on the downloads page. IMPORTANT NOTE: The Docklight RS232 Monitor software does not support the EZ-Tap Pro hardware module at this time. Docklight plans to support EZ-Tap Pro in a future product release.

Developing Custom software with the EZ-Tap Pro Windows API
For users requiring more sophisticated data extraction and analysis Stratus Engineering provides the EZ-Tap/ EZ-Tap Pro API, a Windows-DLL that allows the user to develop custom software that interfaces directly with EZ-Tap Pro. The EZ-Tap Pro API interfaces directly to EZ-Tap Pro hardware for low latency access and provides exact microsecond timing for all data and RTS/CTS handshaking events. EZ-Tap Pro requires EZ-Tap Driver DLL version 1.6 or higher.


Download pdf version








Embedded applications design

©2007 Stratus Engineering, Inc. All brand or product names are trademarks or registered trademarks of their respective holders. The specification and information herein are subject to change without notice.
Engineering Design for Embedded Systems
Stratus Engineering, Inc.
Electronic Design for Embedded Systems - Engineering Firm
10755 Scripps Poway Pkwy., Suite 473
San Diego, CA 92131
Phone: 858-663-1841
FAX: 858-586-1841
 
About Stratus EngineeringEngineering Firm San DiegoEngineering ClientsDownload InstructionsRS232 SnifferEZ-Wave Signal GeneratorStratus Engineering ProductsEngineering Customer TestimonialsRS232 Sniffer User ManualsElectronic Design ServicesASIC / FPGA / CPLD Logic DesignBoard Level Hardware DesignSerial Port SnifferEmbedded Applications DesignEmbedded Firmware DesignEZ-Tap User GuideRS232 breakoutRS-232, RS-422, RS-485 Sniffer BreakoutVersaTap User GuideRS-232 Monitoring SoftwareSite Map